Canon imagePROGRAF GP-300 - Manual (Page 181)

Hard disk settings
This setting item is displayed by tapping Printer settings after tapping ( Setup ) on the HOME
screen.
Important
• The administrator password is required to change settings if it is enabled for changing settings using the
operation panel.
• Output method •
Selects the printing method for jobs received from software other than the printer driver. When using the
printer driver, configure settings on the printer driver.
◦ Print ◦
Performs printing as usual.
◦ Print (auto delete) ◦
Deletes the data from the printer's hard disk after printing is completed.
◦ Save to job box ◦
Only saves the print job in job box without printing it.
• Save first and print •
A setting for jobs received from software other than the printer driver. When using the printer driver,
configure settings on the printer driver. Select
ON to print the job after it has been saved.
• Common job box settings •
Select Print (auto delete) to print without saving jobs in common job box.
• File deletion settings •
Selects the data erasing method when deleting a Print job or Saved job , or when Print (auto delete) is
selected in Output method or Common job box settings .
◦ Fast ◦
Erases file management data for print job data stored on the printer's hard disk. Choose this method
for relatively fast erasure. Because only the file management data is erased, the print job data itself
is not erased.
◦ Fast secure ◦
Erases the data encryption key specified for the hard disk drive. Specifying the encryption key again
does not allow you to read and use data saved in the past safely and fast. Select to erase highly
confidential data.
◦ Secure ◦
Overwrites the entire hard disk with 00, FF, and random data (one time each) after the data
encryption key specified for the hard disk drive is erased. Verification is performed to check if the
data was correctly written. Choose this method to erase especially confidential data. It is virtually
181