HP 2/8q Fibre Channel - Manual (Page 117)

Command Line Interface
117 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Admin
command
Opens and closes an Admin session. The Admin session provides commands that change the
fabric and switch configurations. Only one Admin session can be open on the switch at any
time. An inactive Admin session times out after a period of time which can be changed using
the
Set Setup System command. See the “ Set Setup command ” on page 147.
Authority
Admin
Syntax
ADMIN
Keywords
START
Opens the admin session.
END
Closes the admin session. The Hardreset , Logout , Shutdown , and Reset
Switch commands also end an admin session.
CANCEL
Terminates an Admin session opened by another user. Use this keyword with care
because it terminates the Admin session without warning the other user and without
saving pending changes.
Notes
Closing a Telnet window during an admin session does not release the session. In this
case, you must either wait for the admin session to time out, or use the
Admin Cancel
command.
Whoami
command page 173
Reset
command page 131
Set
command page 135
Set Config
command page 137
Set Log
Command page 144
Set Port
command page 146
Set Setup
command page 147
Shutdown
command page 169
Test
command page 169
User
command page 171
Zone
Command page 174
Zoneset
command page 176
Table 44: Commands listed by Authority Level (Continued)
Monitoring commands Administrative commands