MITSUBISHI ELECTRIC J2-JRSERIES MR-J2-03A5 - Manual (Page 126)

9 - 2
9. TROUBLESHOOTING
No. Start-Up Sequence Fault Investigation Possible Cause Refer To
Rotation ripples
(speed fluctuations)
are large at low
speed. Make gain adjustment in the
following procedure:
1. Increase the auto tuning
response level.
2. Repeat acceleration and
deceleration several
times to complete auto
tuning.
Gain adjustment fault Chapter 7 4 Gain adjustment
Large load inertia
moment causes the
servo motor shaft to
oscillate side to side. Make gain adjustment in the
following procedure:
If the servo motor may be
run with safety, repeat
acceleration and
deceleration several times
to complete auto tuning.
Gain adjustment fault Chapter 7
5 Cyclic operation Position shift occurs Confirm the cumulative
command pulses, cumulative
feedback pulses and actual
servo motor position.
Pulse counting error, etc.
due to noise. (2) in this
section