MITSUBISHI ELECTRIC J2-JRSERIES MR-J2-03A5 - Manual (Page 22)

2 - 1
2. INSTALLATION
2. INSTALLATION
CAUTION
y Stacking in excess of the limited number of products is not allowed.
y Install the equipment to incombustible. Installing them directly or close to
combustibles will led to a fire.
y Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
y Do not get on or put heavy load on the equipment to prevent injury.
y Use the equipment within the specified environmental condition range.
y Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the servo
amplifier.
y Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault may
occur.
y Do not subject the servo amplifier to drop impact or shock loads as they are
precision equipment.
y Do not install or operate a faulty servo amplifier.
y When the product has been stored for an extended period of time, consult
Mitsubishi.
2.1 Environmental conditions
Environment Conditions
0 to +55 [ ° C] (non-freezing)
Ambient temperature
32 to +131 [ ° F] (non-freezing)
Ambient humidity 90%RH or less (non-condensing)
− 20 to +65 [ ° C] (non-freezing)
storage temperature
− 4 to +149 [ ° F] (non-freezing)
storage humidity 90%RH or less (non-condensing)
Ambient
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Altitude Max. 1000m (3280 ft) above sea level
5.9 [m/s
2 ] {0.6G} or less
Vibration
19.4 [ft/s 2 ] or less