MITSUBISHI ELECTRIC J2-JRSERIES MR-J2-03A5 - Manual (Page 113)

6 - 15
6. DISPLAY AND OPERATION
6.8.4 Motor-less operation
Without connecting the servo motor, you can provide output signals or monitor the status display as if the
servo motor is running in response to external input signals. This operation can be used to check the
sequence of a host programmable controller or the like.
(1) Operation
After turning off the signal across SON-SG, choose motor-less operation. After that, perform external
operation as in ordinary operation.
(2) Status display
You can confirm the servo status during motor-less operation.
Pressing the "MODE" button in the motor-less operation-ready status calls the status display screen.
With this screen being shown, perform motor-less operation. Every time you press the "MODE" button,
the next status display screen appears, and on completion of a screen cycle, pressing that button
returns to the motor-less operation-ready status screen. For full information of the status display, refer
to Section 6.2. In the test operation mode, you cannot use the "UP" and "DOWN" buttons to change the
status display screen from one to another.
(3) Termination of motor-less operation
To terminate the motor-less operation, switch power off.