MITSUBISHI ELECTRIC J2-JRSERIES MR-J2-03A5 - Manual (Page 20)

1 - 4
1. FUNCTIONS AND CONFIGURATION
1.5 Parts Identification
Used to set parameter
data.
Used to change the
display or data in each
mode.
Used to change the
mode.
Refer To
Chapter6
Name/Application
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
UP DOWN SET
I/O signal connector (CN1A)
Used to connect digital I/O signals.
Name plate
Servo motor connector (CNP2)
Connector for connection of the servo motor.
Power input connector (CNP1)
Used to connect the input power supply/control circuit
power supply/RS-422.
Earth (E) terminal ( )
To conform to the EN Standard, fit the supplied earth
terminal for grounding.
Operation section
Used to perform status display, diagnostic, alarm and
parameter operations.
Chapter6
Section3.3
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Section3.3
Section1.3
Communication connector (CNP3)
Used for connection with a personal computer
(RS-232C).
Section3.9
MODE
Section10.2.1
Section3.3
Section12.1.1
Section10.2.1
Section3.3
Section10.2.1
Section3.3
Section12.1.3