Changing the aging time, Spanning tree algorithm configuration, Changing the aging time -125 – SMC Networks TIGERSWITCH SMC6752AL2 User Manual
Page 172: Spanning tree algorithm configuration -125, Figure 3-55 setting the address aging time -124, 124 changing the aging time
C
ONFIGURING
THE
S
WITCH
3-124
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Attributes
•
Aging Status – Enables/disables the function.
•
Aging Time – The time after which a learned entry is discarded.
(Range: 10-30000 seconds; Default: 300)
Web – Click Address Table, Address Aging. Specify the new aging time,
click Apply.
Figure 3-55 Setting the Address Aging Time
CLI – This example sets the aging time to 400 seconds.
Spanning Tree Algorithm Configuration
The Spanning Tree Algorithm (STA) can be used to detect and disable
network loops, and to provide backup links between switches, bridges or
routers. This allows the switch to interact with other bridging devices (that
is, an STA-compliant switch, bridge or router) in your network to ensure
that only one route exists between any two stations on the network, and
provide backup links which automatically take over when a primary link
goes down.
Console(config)#mac-address-table aging-time 400
Console(config)#