SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 89)

B
ASIC
C
ONFIGURATION
3-41
CLI – Enter the IP address of at least one SMTP server, set the syslog
severity level to trigger an email message, and specify the switch (source)
and up to five recipient (destination) email addresses. Enable SMTP with
the logging sendmail command to complete the configuration. Use the
show logging sendmail command to display the current SMTP
configuration.
Resetting the System
Web – Click System, Reset to reboot the switch. When prompted, confirm
that you want reset the switch.
Figure 3-19 Resetting the System
Console(config)#logging sendmail host 192.168.1.200 4-68
Console(config)#logging sendmail level 4 4-69
Console(config)#logging sendmail source-email
[email protected]
4-70
Console(config)##logging sendmail destination-email
[email protected]
4-70
Console(config)#logging sendmail 4-71
Console(config)#exit
Console#show logging sendmail
4-71
SMTP servers
-----------------------------------------------
1. 192.168.1.200
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. [email protected]
SMTP source email address: [email protected]
SMTP status: Enabled
Console#