SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 487)

M
ULTICAST
F
ILTERING
C
OMMANDS
4-247
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
- ethernet unit/port
- unit - Stack unit. (This is unit 1)
- port - Port number. (Range: 1-52)
- port-channel channel-id (Range: 1-4)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network
to an interface (port or trunk) on your router, you can manually
configure that interface to join all the current multicast groups.
Table 4-66 Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter Adds a multicast router port GC 4-247
show ip igmp snooping
mrouter Shows multicast router ports PE 4-248