SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 360)

C
OMMAND
L
INE
I
NTERFACE
4-120
Command Usage
• When you create a new ACL or enter configuration mode for an
existing ACL, use the permit or deny command to add new rules to
the bottom of the list. To create an ACL, you must add at least one
rule to the list.
• To remove a rule, use the no permit or no deny command followed
by the exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Example
Related Commands
permit, deny 4-120
ip access-group (4-125)
show ip access-list (4-124)
permit, deny (Standard ACL)
This command adds a rule to a Standard IP ACL. The rule sets a filter
condition for packets emanating from the specified source. Use the no
form to remove a rule.
Syntax
[no] {permit | deny} {any | source bitmask | host source}
• any – Any source IP address.
• source – Source IP address.
• bitmask – Decimal number representing the address bits to match.
• host – Keyword followed by a specific IP address.
Default Setting
None
Command Mode
Standard ACL
Console(config)#access-list ip standard david
Console(config-std-acl)#