SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 333)

F
LASH
/F
ILE
C
OMMANDS
4-93
Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (This is unit 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Console#whichboot
file name file type startup size (byte)
---------------------------- -------------- ------- -----------
Unit1:
Diag_V2.2.1.3.bix Boot-Rom image Y 196020
V2.2.2.2.bix Operation Code Y 1745500
startup Config File Y 6023
------------------------------------------------------------------
Total free space: 340787
Console#