SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 75)

B
ASIC
C
ONFIGURATION
3-27
If you download to a new file name using “tftp to startup-config” or “tftp
to file,” the file is automatically set as the start-up configuration file. To use
the new settings, reboot the system via the System/Reset menu.
Note that you can also select any configuration file as the start-up
configuration by using the System/File/Set Start-Up page.
Figure 3-12 Setting the Startup Configuration Settings
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
To select another configuration file as the start-up configuration, use the
boot system command and then restart the switch.
Console#copy tftp startup-config 4-87
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console#config
Console(config)#boot system config: startup-new
4-93
Console(config)#exit
Console#reload
4-30