SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 213)

VLAN C
ONFIGURATION
3-165
CLI – This example shows the switch configured with primary VLAN 5
and community VLAN 6. Port 3 has been configured as a promiscuous
port and mapped to VLAN 5, while ports 4 and 5 have been configured as
host ports and associated with VLAN 6. This means that traffic for port 4
and 5 can only pass through port 3.
Configuring Private VLAN Interfaces
Use the Private VLAN Port Configuration and Private VLAN Trunk
Configuration menus to set the private VLAN interface type, and associate
the interfaces with a private VLAN.
Command Attributes
• Port/Trunk – The switch interface.
• PVLAN Port Type – Sets the private VLAN port types.
- Normal – The port is not configured into a private VLAN.
- Host – The port is a community port or an isolated port. A
community port can communicate with other ports in its own
community VLAN and with the designated promiscuous port(s). An
isolated port can only communicate with the designated
promiscuous port(s); it cannot communicate with other hosts in its
own isolated VLAN.
- Promiscuous – A promiscuous port can communicate with all
interfaces within a private VLAN.
• Primary VLAN – Conveys traffic between promiscuous ports, and
between promiscuous ports and community ports within the
associated secondary VLANs. If PVLAN type is “Promiscuous,” then
Console#show vlan private-vlan 4-216
Primary Secondary Type Interfaces
-------- ----------- ---------- ------------------------------
5 primary Eth1/ 3
5 6 community Eth1/ 4 Eth1/ 5
Console#