SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 485)

M
ULTICAST
F
ILTERING
C
OMMANDS
4-245
ip igmp snooping query-max-response-time
This command configures the query report delay. Use the no form to
restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries. (Range: 5-25)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• This command defines the time after a query, during which a response
is expected from a multicast client. If a querier has sent a number of
queries defined by the ip igmp snooping query-count, but a client
has not responded, a countdown timer is started using an initial value
set by this command. If the countdown finishes, and the client still has
not responded, then that client is considered to have left the multicast
group.
Example
The following shows how to configure the maximum response time to
20 seconds:
Related Commands
ip igmp snooping version (4-240)
ip igmp snooping query-max-response-time (4-245)
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#