SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 287)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-47
The SSH server on this switch supports both password and public key
authentication. If password authentication is specified by the SSH client,
then the password can be authenticated either locally or via a RADIUS or
TACACS+ remote authentication server, as specified by the
authentication login command on page 4-95. If public key authentication
is specified by the client, then you must configure authentication keys on
both the client and the switch as described in the following section. Note
that regardless of whether you use public key or password authentication,
you still have to generate authentication keys on the switch and enable the
SSH server.
To use the SSH server, complete these steps:
1. Generate a Host Key Pair – Use the ip ssh crypto host-key generate
command to create a host public/private key pair.
ip ssh crypto
host-key generate Generates the host key PE 4-53
ip ssh crypto zeroize Clear the host key from RAM PE 4-54
ip ssh save host-key Saves the host key from RAM to flash
memory PE 4-54
disconnect Terminates a line connection PE 4-25
show ip ssh Displays the status of the SSH server and
the configured values for authentication
timeout and retries PE 4-55
show ssh Displays the status of current SSH sessions PE 4-55
show public-key Shows the public key for the specified user
or for the host PE 4-57
show users Shows SSH users, including privilege level
and public key type PE 4-84
Table 4-15 SSH Commands (Continued)
Command Function Mode Page