SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 259)

L
INE
C
OMMANDS
4-19
Example
To set the timeout to two minutes, enter this command:
Related Commands
silent-time (4-21)
exec-timeout (4-14)
exec-timeout
This command sets the interval that the system waits until user input is
detected. Use the no form to restore the default.
Syntax
exec-timeout [seconds]
no exec-timeout
seconds - Integer that specifies the number of seconds.
(Range: 0-65535 seconds; 0: no timeout)
Default Setting
• CLI: No timeout
• Telnet: 10 minutes
Command Mode
Line Configuration
Command Usage
• If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
• This command applies to both the local console and Telnet
connections.
• The timeout for Telnet cannot be disabled.
• Using the command without specifying a timeout restores the default
setting.
Console(config-line)#timeout login response 120
Console(config-line)#