SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 83)

B
ASIC
C
ONFIGURATION
3-35
Web – Click System, Log, System Logs. Specify System Log Status, set the
level of event messages to be logged to RAM and flash memory, then click
Apply.
Figure 3-15 System Logs
CLI – Enable system logging and then specify the level of messages to be
logged to RAM and flash memory. Use the show logging command to
display the current settings.
Remote Log Configuration
The Remote Logs page allows you to configure the logging of messages
that are sent to syslog servers or other management stations. You can also
limit the error messages sent to only those messages below a specified
level.
Console(config)#logging on 4-59
Console(config)#logging history ram 0 4-60
Console(config)#end
Console#show logging flash
4-64
Syslog logging: Enabled
History logging in FLASH: level emergencies
Console#