Samsung SCX-6320F - Manual (Page 220)

D.11
D
I NSTALLING O PTIONS
Configuring Netware
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of network communication frames must be specified
on the printer. In most cases, you can keep the default setting
on “Auto.” However, you can manually set the frame type format
if required.
• Auto (default): Automatically senses and limits the frame
type to the first one detected.
• Enable 802.3: Limits the frame type to IPX over Enable
802.3 frames. All others are discarded.
• Enable Ethernet 2: Limits the frame type to IPX over
Ethernet Frames. All others are discarded.
• Enable 802.2: Limits the frame type to IPX over Enable
802.2 with Enable 802.2 frames. All others are discarded.
• Enable 802.2 SNAP: Limits the frame type to IPX over SNAP
with Enable 802.2 frames. All others are discarded.
Restoring the Network Configuration
You can return the network configuration to its default settings.
1 Press Menu until “Sys. Admin Tools” appears.
2 Press the scroll buttons to display “Network Setup” and
press Enter.
3 Press the scroll buttons until “Use Factory Default” appears
and press Enter.
4 Press the scroll buttons to select “Yes” and press Enter.
To cancel restoring, select “No.”
5
To return to Standby mode, press Stop/Clear.