Panasonic KX-TCD735ALM - Manual (Page 2)

2
Dear purchaser,
You have acquired a KX-TCD735ALM, which is a product made in regard with the European
Standards for Cordless Telephones (DECT). DECT technology is characterised by high-security
protection against interceptions as well as high-quality digital transmission.
This telephone was designed for a wide range of applications. For example, this telephone can be
used within a network of base units and handsets, constituting a telephone system which:
•
operates up to 6 handsets at one base unit
•
allows an intercom between 2 handsets
•
allows the operation of a handset at up to 4 base units, expanding the communication radio area.
This telephone may be used for:
•
operating several handsets
•
operating at several base units
•
connecting the base unit to a PBX.
Installation
Attached to this telephone is an approval label. This label is evidence that it is a “Permitted
Attachment” which has been authorised to be connected to your telephone service.
Conditions relating to connection and operation of this Permitted Attachment are contained in
Telecommunications General By-Law 220 (5).
You are authorised to install this Permitted Attachment yourself by plugging it into the line socket of
any regular telephone. You may connect it in place of your existing telephone or to any spare
telephone socket installed in your premises.
To disconnect your existing telephone you must first remove its plug from the line socket. You can then
insert the plug of your Permitted Attachment into the socket and use your equipment.
If the plug of your existing telephone cannot be readily removed, you will have to remove the screw
securing it. To do this proceed as follows:
1.Loosen screw “A” sufficiently to remove the socket cover.(See Fig. 1.)
2.Remove screw “B” and withdraw the plug. (See Fig. 2.)
3.Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socket recess. (If the
screw is too long, increase the hole depth or replace the screw with one 5 mm shorter.)
4.Replace socket cover and tighten screw “A”. (See Fig. 4.)
Important Information
Instructions to customer
SOCKET
SCREW “A”
PLUG
Fig. 1
TELEPHONE CORD
Connect to the PLUG
as shown in Fig. 1. ( )
SCREW
B
Fig. 2
SCREW
B
Fig. 3
SOCKET
SCREW A
Fig. 4
KX-TCD735ALM(E)-1(02~31) 2002.06.21 4:48 PM Page 2