Panasonic KX-TCD735ALM - Manual (Page 93)

93
Chapter 5
Answering System
Direct Remote Operation
Once you have entered the remote code, you can also control your unit by direct commands instead of
using the voice menu. Hang up anytime to end the remote operation.
Direct commands
NEW MESSAGE PLAYBACK
•
Only new messages are played back.
ALL MESSAGE PLAYBACK
•
All messages are played back.
REPEAT (During playback)
•
The current message is repeated.
SKIP (During playback)
•
The current message is skipped. The
next message is played.
STOP (During playback)
GREETING MESSAGE RECORDING
•
Talk immediately after the long beep.
•
The recording is stopped.
•
The recorded message is played.
RECORD
4
5
1
2
9
7
9
4
5
0
ERASING A SPECIFIC MESSAGE
(During playback)
•
The current message is erased.
•
A short beep will sound and the
next message will be played.
ERASING ALL MESSAGES
•
All recorded messages are
erased.
•
A long beep sounds and “No
message” is heard.
ANSWERING SYSTEM OFF
•
“Answer off” is heard.
•
The unit hangs up and will not
answer calls until turned on
again.
DISCONNECT
•
The call is terminated.
Turning on the answering system
1 Call your unit and wait for 15 rings.
2 Press the remote code within 10 seconds after the long beep.
•
The unit will answer and the greeting message will be played.
•
The answering system will turn on. Hang up or enter the remote code for other options.
•
If your remote code is not stored, you cannot turn on the answering system remotely.
KX-TCD735ALM(E)-4(76~100) 2002.06.21 8:18 PM Page 93