Panasonic KX-TCD735ALM - Manual (Page 91)

91
Chapter 5
Answering System
Setting the Remote Code
The 3-digit remote code prevents unauthorised use of your unit for listening to recorded messages.
The remote code is not preset.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press .
•
“ Remote Operation ” is displayed.
4 Press . 1
5 Enter a 3-digit remote code number to
set the remote operation ON.
OR
Press
to set the remote operation
OFF.
6 Press .
•
A beep sounds.
•
To change the remote code, repeat from
step 2.
•
If 5 beeps sound in step 5, a 3-digit number
was not entered. Start again from step 2 and
enter a 3-digit number.
•
If a remote code is not programmed, you
cannot use the unit remotely.
KX-TCD735ALM(E)-4(76~100) 2002.06.21 5:30 PM Page 91