Panasonic KX-TCD735ALM - Manual (Page 69)

69
Chapter 4
Programmable Functions on the Base Unit
I n p u t C o m m a n d
12 1 3 - 1 2 3 4 5 6
5 Press .
•
The current number of rings is displayed
at the end of the 2nd line.
6 Select the number of rings 1 through 6
with the dialing buttons
to , then
press .
•
A beep sounds.
•
The display will return to “ Setting
Base ”. To return to the standby mode,
press .
6 1
Selecting the “Selected then All Handsets” Ringer Mode
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 67).
•
The current mode is displayed.
4 Press , then select handset
number(s) you desire to ring first.
•
The selected handset number(s) blink(s).
Ex. All registered handsets (1 to 6) are
displayed and selected handset
numbers (1 and 5) to ring first blink.
3
1
with the Handset
Key Tones
with the Handset
You can select the base unit keys to sound tones (key tone) or not.
The factory preset is 1 (ON).
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press then .
•
The current setting is displayed.
1: ON 0: OFF
1 2
4 Press for ON.
OR
Press for
OFF
Ex. 1 (ON) is selected.
5 Press .
•
A beep sounds.
•
The display will return to “ Setting Base ”.
To return to the standby mode, press .
0
1
I n p u t C o m m a n d
12 21 5 1 7 5 9 0
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 69