Panasonic KX-TCD735ALM - Manual (Page 73)

73
Chapter 4
Programmable Functions on the Base Unit
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 67).
•
All registered handset number(s) and base
unit number “0” are displayed.
•
The handset number(s) and base unit
number “0” flash if the call restriction
number(s) is/are already set.
Ex. 1 base unit and 6 handsets are
registered.
4 Enter the handset number(s) which you
desire to restrict.
•
The selected handset number(s) flash(es).
•
If you misdial, press the number(s) again.
6
0 0
Call Restriction
You can restrict desired handset(s) and base unit from dialling selected phone numbers. Phone
numbers beginning with the restricted digits cannot be dialled out. For example, if “00” is assigned as
the call restriction number, international calls cannot be made.
For selected handset(s) and base unit, you can assign up to 6 call restriction numbers (up to 8 digits).
The factory preset is OFF.
•
You can exit the programming mode any time
by pressing
.
Ex. Handset number 5 is selected.
5 Press .
6 Enter a call restriction number, up to
8 digits.
•
Pressing erases the digit to the left of
the cursor. To erase all digits, press and
hold .
7 Press .
•
A beep sounds.
•
If you desire to set another call restriction,
follow steps 6 to 7. If you finish, go to step 8.
8 Press .
•
The display will return to “ Setting
Base ”. To return to the standby mode,
press .
C
C
with the Handset
Setting the Call Restriction
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
When you dial a restricted number
The call is restricted, and the dialled number flashes.
Ex. The restricted number is “00”.
I n p u t C o m m a n d
12 6 0 1 2 3 4 5 6
I n p u t C o m m a n d
12 6 0 1 2 3 4 5 6
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 73