Panasonic KX-TCD735ALM - Manual (Page 66)

66
Summary of Programmable Function on the Base Unit
Press To select “all handsets” ringer mode (p. 68)
Press To select “selected handset(s)” ringer mode (p. 68)
Press To select “selected, then all handsets” ringer mode (p. 69)
To set the base unit key tone ON/OFF (p. 69)
Press To select the base unit ringer volume (p. 70)
To select the base unit ringer type (p. 70)
Press To select the Time Break Recall/mode (p. 71)
Press To select the pause timing (p. 72)
Press To change the 4-digit base unit PIN (p. 67)
Press To set the call restriction (p. 73)
Press
then 4-digit base unit PIN
then 4-digit base unit PIN
then 4-digit base unit PIN To cancel a handset registration in the base unit (p. 97)
, 4-digit base unit PIN, then
, 4-digit base unit PIN, then
1 , 4-digit base unit PIN, then
, 4-digit base unit PIN, then
, 4-digit base unit PIN, then
then
then
1
1
2
Press 2
1
2
3
3
2
Press then 2 1
3
3
2
3
5
6
7
Press To reset the base unit settings (p. 75)
Press To set the date/time (p. 18)
then 4-digit base unit PIN 0
Press
Press
Press
Press
then 1
then 2
then 3
then 4
To set the remote code (p. 91)
To select the number of rings (p. 84)
To select the caller's recording time (p. 85)
To set the monitor function ON/OFF (p. 85)
You can select and execute answering system by pressing direct command as follows without
programming. See the corresponding pages for function details.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
•
If any key is not pressed for over 60 seconds, the display will return to “ Setting Base ”.
<Direct command>
Press . Press or until the arrow points to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
KX-TCD735ALM(E)-3(50~75) 2002.06.21 8:15 PM Page 66