Panasonic KX-TCD735ALM - Manual (Page 68)

68
1 Follow steps 1 to 3 on Selecting the All
Handsets Ringer Mode.
2 Press , then current setting is
displayed.
•
The selected handset number(s) blink(s)
and ring(s).
3 Select the handset number(s) you desire
to ring with keypad.
•
If you select the handset number which
does not blink, it starts blinking.
Ex. All registered handset number (1 to 6)
is displayed and selected handset
numbers (1 and 5 ) blink.
2
Ringer Mode Selection
You can select one of 3 base unit ringer modes.
—All handsets: All handsets registered in the base unit ring at the same time.
—Selected handset(s): Only the selected handset(s) ring(s) at the same time.
—Selected then all handsets: The selected handset(s) ring(s) first, then if no answer, all handsets start
ringing.
The factory preset is All handsets.
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 67).
•
The current mode is displayed.
1
I n p u t C o m m a n d
12 1 2 - 1 2 3 4 5 6
4 Press .
5 Press .
•
A beep sounds.
•
The display will return to “ Setting
Base ”. To return to the standby mode,
press .
1
4 Press .
•
A beep sounds.
•
The display will return to “ Setting
Base ”. To return to the standby mode,
press .
Selecting the “All Handsets” Ringer Mode
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
Selecting the “Selected Handset(s)” Ringer Mode
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
with the Handset
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 68