Panasonic KX-TCD735ALM - Manual (Page 80)

Answering System Operations with the Handset
80
To playback new recorded
message(s)
1 Press (INT) then .
2 After the function menu is displayed,
press or until the arrow points
to “ Play New Msg ”, then press .
OR
Press (4).
•
New recorded message(s) is/are played
back from the speaker on the handset if
recorded.
•
The unit will announce the remaining
recording time after playback.
•
The display will return to “ Remote
Operation ”. To return to the standby
mode, press or wait for 30 seconds.
To playback all recorded
message(s)
1 Press (INT) then .
2 After the function menu is displayed,
press or until the arrow points
to “ Play All Msg ”, then press .
OR
Press (5).
•
All recorded message(s) is/are played back
from the speaker on the handset if
recorded.
•
The unit will announce the remaining
recording time after playback.
•
The display will return to “ Remote
Operation ”. To return to the standby
mode, press or wait for 30 seconds.
Recorded Message
Incoming messages and memo messages are stored in chronological order. New messages cannot be
recorded when “
Memory is Full” is heard. We recommend you to erase unnecessary message after
each playback in order to leave more time for recording new message(s). If new message(s) is/are
recorded, the number of recorded message on the handset display will flash. When memory is full, it
will flash faster.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
During playback of a recorded message, press then .
•
One recorded message is erased.
•
If erasing message with more than 1 new message in memory then second message will begin
playback.
•
The display will return to “ Remote Operation ”. To return to the standby mode, press
or wait for 30 seconds.
4
To erase one recorded message with direct command
KX-TCD735ALM(E)-4(76~100) 2002.06.21 5:30 PM Page 80