Panasonic KX-TCD735ALM - Manual (Page 63)

63
Chapter 3
Programmable Functions on the Handset
To set the direct call number
1 Press .
2 Press or until the arrow points to
“ Setting Handset ”, then press .
3 Press or until the arrow points to
“ Call Option ”, then press .
4 Press or until the arrow points to
“ Direct Call No. ”, then press .
•
“ E n t e r P h o n e No ” is displayed.
5 Enter the phone number up to 24 digits.
•
If you misdial, press . The digits are
erased from the right. To erase all digits,
press and hold
.
6 Press .
7 While “ Save ” is at the arrow, press .
8 Press or to select “ ON ” or
“ OFF ”, then press .
•
A beep sounds.
•
The display will return to “ Direct Call
No. ”. To return to the standby mode, press
or wait for 60 seconds. “ ” will be
shown at the top right corner on the
standby mode display when set to ON.
C
C
with the Handset
Direct Call
You can easily make a call using a stored direct call number by pressing or . Incoming
calls are accepted. The factory preset is OFF.
After storing the direct call number, the unit will automatically switch to the direct call mode. When the
direct call mode is on, you can ONLY dial the number stored in the direct call memory.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
To set the direct call mode
ON/OFF
1 Follow steps 1 to 3 on To set the direct
call number.
2 Press or until the arrow points
to “ Direct ON/OFF ”, then press .
3 Press or to select “ ON ” or
“ OFF ”, then press .
•
A beep sounds.
•
The display will return to “ Direct
ON/OFF ”. To return to the standby mode,
press or wait for 60 seconds. “ ”
will be shown at the top right corner on the
standby mode display when set to ON.
•
When set to off , “ ” will go out.
To dial the stored number
Make sure that “ ” is displayed, then press
or .
•
The number stored in the direct call memory is
automatically dialled.
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 63