Panasonic KX-TCD735ALM - Manual (Page 67)

67
Chapter 4
Programmable Functions on the Base Unit
Base Unit PIN
with the Handset
Setting the 4-digit Base Unit PIN
You can program a 4-digit base unit PIN (Personal Identification Number). The factory preset is 0000.
Changing the PIN may prevent the unauthorised use of your unit by another person.
—Cancelling a Handset Registration in the
Base Unit (p. 97)
—Reset the Base Unit Settings (p. 75)
4 Enter the new 4-digit base unit PIN
TWICE.
•
A beep sounds.
•
The display will return to “ Setting
Base ”. To return to the standby mode,
press .
—Ringer Mode Selection (p. 68, 69)
—Selecting Time Break Recall/Mode (p. 71)
—Selecting the Pause Timing (p. 72)
—Call Restriction (p. 73)
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
•
“ Input Command ” is displayed.
3 Press , then enter the current 4-digit
base unit PIN.
•
The factory preset is 0000.
5
•
If 5 beeps sound in step 3, the entered 4-digit
base unit PIN is incorrect. Enter the correct
4-digit base unit PIN.
•
You can exit the programming mode any time
by pressing
.
I n p u t C o m m a n d
5 ----
I n p u t C o m m a n d
5 ---- ----
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
Once you have programmed the 4-digit base unit PIN, you cannot confirm it. We recommend you
to write down the 4-digit base unit PIN. If you forget it, please contact Panasonic’s Customer Care
Centre.
You need to enter the 4-digit base unit PIN when using the following functions.
4-digit base unit PIN
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 67