NEC NEAX2000 IVS ND-45492 - Manual (Page 48)

ND-45492 (E) CHAPTER 3
Addendum-001 Page 31
JANUARY, 1999 Revision 2.1
(8) The cable connections on the PZ-PW86 card are shown in Figure 003-9 .
(a) PZ-PW86 (A)
Figure 003-9 Cable Connection on the PZ-PW86 (1 of 3)
NAP 200-003
Sheet 9/37
Installation of Main Equipment
PZ-PW86(A)
MJ
MN
ON
BATTERY MODE SWITCH
GND Note
FG
–27V
PWR CNT CA-A
PWR CA-A
BATTERY CABLE/PWR CA-A
TO PWR1
TO OTHER
AC CORD-A
TO AC MAINS INPUT
TO
POWER OUTPUT
POWER OUTPUT
TO PWR0A CONNECTOR
TO PWR0B CONNECTOR
CABLE (+5V, –27V,E)
CABLE (CR, E)
CONNECTOR
PZ-PW86
TO AUXILIARY
BATTERY CONNECTOR (BATT2)
ON
OFF
100/120V
240V
EQUIPMENT
TO BATTERY OR
OTHER PZ-PW86
GREEN
WHITE
BLACK
AC CORD-B
OR
(FOR 1-PIM SYSTEMS)
TO THE TERMINAL BLOCK AT BASE
(FOR MULTIPLE PIM SYSTEMS)
FRAME GROUND TERMINAL ON THE CHASSIS
Set the appropriate voltage before turning on
the SW switch.
CAUTION
Note: If GND (Signal GND) has to be separated from
FG (Frame GND), remove the link between
GND and FG terminals.
1: NO CONNECTION
2: ON: OPEN/FLOAT 1
OFF: SEAL/FLOAT 2
–
O
BATTERY CONNECTOR (BATT1)
1
2
ON
(FOR 1-PIM SYSTEMS)
L
N
NOMINAL
AC INPUT
TO TERMINAL
MARKED:
ON BASE
(See Figure 003-11 )