NEC NEAX2000 IVS ND-45492 - Manual (Page 49)

CHAPTER 3 ND-45492 (E)
Page 32 Addendum-001
Revision 2.1 JANUARY, 1999
(b) PZ-PW86 (C)
Figure 003-9 Cable Connection on the PZ-PW86 (2 of 3)
NAP 200-003
Sheet 10/37
Installation of Main Equipment
PZ-PW86(C)
MJ
MN
ON
BATTERY MODE SWITCH
GND Note 2
FG
–27V
PWR CNT CA-A
PWR CA-A
BATTERY CABLE/PWR CA-A
TO PWR1
TO OTHER
AC CORD-A
TO AC MAINS INPUT
TO
POWER OUTPUT
POWER OUTPUT
TO PWR0A CONNECTOR
TO PWR0B CONNECTOR
CABLE (+5V, –27V,E)
CABLE (CR, E)
CONNECTOR
PZ-PW86
TO AUXILIARY
BATTERY CONNECTOR (BATT2)
ON
OFF
100/120V
240V
EQUIPMENT
TO BATTERY OR
OTHER PZ-PW86
GREEN
WHITE
BLACK
AC CORD-B
OR
(FOR 1-PIM SYSTEMS)
TO THE TERMINAL BLOCK AT BASE
(FOR MULTIPLE PIM SYSTEMS)
FRAME GROUND TERMINAL ON THE CHASSIS
Set the appropriate voltage before turning on
the SW switch.
CAUTION
Note 1: Follow the Label on Front Plate of the PZ-
PW86(C).
Note 2: If GND (Signal GND) has to be separated from
FG (Frame GND), remove the link between
GND and FG terminals.
1: NO CONNECTION
OFF: OPEN/FLOAT 1
2: ON: SEAL/FLOAT 2
–
O
BATTERY CONNECTOR (BATT1)
1
2
ON
(FOR 1-PIM SYSTEMS)
L
N
NOMINAL
AC INPUT
TO TERMINAL
MARKED:
ON BASE
(See Figure 003-11 )
Note 1
TO PWR0D CONNECTOR
POWER OUTPUT CABLE (+90V,E)