NEC NEAX2000 IVS ND-45492 - Manual (Page 50)

ND-45492 (E) CHAPTER 3
Addendum-001 Page 33
JANUARY, 1999 Revision 2.1
(c) PZ-PW86 (D)
Figure 003-9 Cable Connection on the PZ-PW86 (3 of 3)
NAP 200-003
Sheet 11/37
Installation of Main Equipment
PZ-PW86(D)
MJ
MN
ON
BATTERY MODE SWITCH
GND Note 2
FG
–27V
PWR CNT CA-A
TO PWR1
AC CORD-A
TO AC MAINS INPUT
TO
POWER OUTPUT
POWER OUTPUT
TO PWR0A CONNECTOR
TO PWR0B CONNECTOR
CABLE (+5V, –27V,E)
CABLE (CR, E)
CONNECTOR
TO AUXILIARY
BATTERY CONNECTOR (BATT2)
ON
OFF
100/120V
240V
EQUIPMENT
GREEN
WHITE
BLACK
AC CORD-B
OR
(FOR 1-PIM SYSTEMS)
TO THE TERMINAL BLOCK AT BASE
(FOR MULTIPLE PIM SYSTEMS)
FRAME GROUND
Note 1: Follow the Label on Front Plate of
PZ-PW86(D).
Note 2: If GND (Signal GND) has to be sep-
arated from FG (Frame GND), re-
move the link between GND and FG
terminal.
1: NO CONNECTION
OFF: OPEN/FLOAT 1
2: ON: SEAL/FLOAT 2
–
O
1
2
ON
TERMINAL ON THE
(See Figure 003-11 )
Note 1
TO PWR0D CONNECTOR
POWER OUTPUT CABLE (+90V,E)
TO OTHER PZ-PW86
PWR CA-A
TO BATTERY OR
OTHER PZ-PW86
BATTERY CONNECTOR (BATT1)
BATTERY CABLE/PWR CA-A
CHASSIS (FOR 1-PIM SYSTEMS)
L
N
NOMINAL
AC INPUT
TO TERMINAL
MARKED:
ON BASE
Set the appropriate voltage before
turning on the SW switch.
CAUTION