NEC NEAX2000 IVS ND-45492 - Manual (Page 63)

CHAPTER 3 ND-45492 (E)
Page 46
Revision 2.0
2. Wall Mounting Installation
(1) Using four appropriate fasteners (locally provided; see Table 003-1 ) for the type of wall construction, se-
cure the RACK PARTS as shown in Figure 003-21 . For the wall mounting points, refer to Figure 002-2 in
NAP-200-002.
Note: For the wall-mounting installation, a concrete wall is recommended because the concrete wall is more firm
to mount the PBX than a wooden wall or a plaster board. The plaster board is the most infirm wall of the
three.
NAP 200-003
Sheet 24/37
Installation of Main Equipment
Table 003-1 Recommended Fasteners
WALL TYPE RECOMMENDED FASTENER
PLASTER BOARD
[THICKNESS Min. 9.6 mm
(0.38 inch)] MOLLY ANCHOR TYPE Min. 3.5 mm (0.14 inch) DIA.
Max. 4.5 mm (0.17 inch) DIA
WOOD WOOD TYPE SCREWS Min. 3.5 mm (0.14 inch) DIA
Max. 4.5 mm (0.17 inch) DIA
CONCRETE ANCHOR BOLT TYPE Recommended 4 mm (0.16 inch) by
25 mm (0.98 inch)