NEC NEAX2000 IVS ND-45492 - Manual (Page 98)

ND-45492 (E) CHAPTER 3
Page 81
Revision 2.0
2. Cable Running to the External MDF
(1) When not using the cable hole of the PIM
(a) Bring the MDF cable up to the Main Equipment through the cable hole(s) of the BASE.
(b) Connect the champ connector of each MDF cable to an LTC connector located on a PIM using the
screws provided, as shown in Figure 006-2 .
(c) Pare the sheath of each MDF cable and secure the shield to the front bracket on the PIM using tie
wraps, as shown in Figure 006-2 .
Figure 006-2 Cable Running to the External MDF (1 of 2)
NAP 200-006
Sheet 3/7
Cable Running to the MDF
LTC CONNECTOR
CHAMP CONNECTOR
FRONT
TO MDF
BASE
PIM0
PIM1
PBX
TIE WRAP
SHIELD
PIM
MDF CABLE
25 ~ 30 mm
(1.0 ~ 1.2 inch)