Renesas M32R-FPU - Manual (Page 31)

2
2-7 M32R-FPU Software Manual (Rev.1.01)
The addressing mode of the BRA, BL, BC and BNC instructions can specify an 8-bit or
24-bit immediate value. The addressing mode of the BEQ, BNE, BEQZ, BNEZ, BLTZ,
BGEZ, BLEZ, and BGTZ instructions can specify a 16-bit immediate value.
In the JMP and JL instructions, the register value becomes the branch address.
H o w e v e r , t h e l o w - o r d e r 2 - b i t v a l u e o f t h e r e g i s t e r i s i g n o r e d . I n o t h e r b r a n c h
instructions, (PC value of branch instruction) + (sign-extended and 2 bits left-shifted
immediate value) becomes the branch address. However, the low order 2-bit value of the
address becomes "00" when addition is carried out. For example, refer to Figure 2.1.1.
W h e n i n s t r u c t i o n A o r B i s a b r a n c h i n s t r u c t i o n , b r a n c h i n g t o i n s t r u c t i o n G , t h e
immediate value of either instruction A or B becomes 4.
Simultaneous with execution of branching by the JL or BL instructions for subroutine
calls, the PC value of the return address is stored in R14. The low-order 2-bit value of
the address stored in R14 (PC value of the branch instruction + 4 ) is always cleared to
"0". For example, refer to Figure 2.1.1. If an instruction A or B is a JL or BL instruction,
the return address becomes that of the instruction C.
Fig. 2.1.1 Branch addresses of branch instruction
H'00
H'04
H'08
H'0C
H'10
instruction A instruction B
instruction C instruction D
instruction E
instruction F
instruction G instruction H
address +0 +1 +2 +3
1 word (32 bits)
branch instruction
INSTRUCTION SET
2.1 Instruction set overview