RAD Data comm ASMi-52 - Manual (Page 149)

Installation and Operation Manual Appendix B IR-IP Interface Module
ASMi-52 Ver. 2.5 Quick Setup Guide B-13
ASMi-52 with IR-IP
LAN IP Address: 192.168.1.2
Mask: 255.255.255.248
DHCP Server
IP Network
Figure B-7. Selecting the IP Subnet Mask
Leaving the DHCP Server IP Address field blank disables the DHCP relay.
3. Set the protocol requirements.
Reading Protocol from DIP Switches –
Selecting YES for this parameter (Quick Start Menu) forces IR-IP router
card to use the WAN protocol selected by section 2 of its DIP switch: PPP
or Frame Relay.
If you want to be able to select the WAN protocol by means of the
Protocol field (parameter 7) of the Quick Setup menu, select NO.
Protocol – Used to select the WAN protocol to be used by the IP router card: PPP,
HDLC or Frame Relay.
This parameter is available only if the Read Protocol from DIP Switches
parameter is set to NO.
Note