RAD Data comm ASMi-52 - Manual (Page 55)

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.5 Configuring ASMi-52 for Management 4-5
ASMi-52
Management Access
1. TELNET allowed (access allowed)
2. WEB allowed (access allowed)
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-6. Management Access Menu
Configuring Dedicated Timeslots
ASMi-52 units with an E1 or T1 port support management via a dedicated
timeslot.
A remote E1 device can be managed via DTS if the DTS mode is enabled in both
the CO unit and the CPE unit. The MNG timeslot is transferred over the SHDSL to
the E1 CPE, the CPE forwards the MNG timeslot over the E1 line to the next
device in the chain.
• Allocate the same timeslot number for MNG in all devices in the chain. With DTS
mode enabled in all devices, the chain can be managed remotely from one NMS.
In T1 systems, the DTS manages the local unit only; it is not forwarded over SHDSL.
To configure dedicated timeslots:
1. From the DTS Configuration menu (Main menu > Configuration > System
Configuration > Management > DTS Configuration), configure the dedicated
timeslot in the following order (see
Figure 4-7 ):
Assign a DTS IP address
Assign a DTS IP mask
Enable the DTS mode.
2. Check the status of the DTS configuration in the Rem Agent Table (see Figure 4-8 ).
3. From the Management menu, select Save to save the changes.
In the Map Timeslot menu ( Figure 4-36 ), the dedicated timeslot value
changes to MNG (management).
ASMi-52
DTS Configuration
1. DTS Mode (Enable)
2. DTS IP Address
(172.17.161.184)
3. DTS IP Mask (255.255.255.0)
4. DTS to Remote (Off/On)
5. Rem Agent Table <[]
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-7. DTS Configuration Menu
Note