RAD Data comm ASMi-52 - Manual (Page 68)

Chapter 4 Configuration Installation and Operation Manual
4-18 Configuring ASMi-52 System Parameters ASMi-52 Ver. 2.5
ASMi-52
Port Control
1. Port Control Mode
> (Terminal)
2. Terminal >
3. Dial out >
4. Save
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-22. Port Control Menu
Configuring the Port Control Mode
The Control port of ASMi-52 operates in one of the following modes:
• Terminal – direct connection to the control terminal (DCE mode) or to the
modem (DTE mode)
• Dial-out – connection to a dial-out modem for alarm reporting
• Currently, the connection to ASMi-52 via SLIP is disabled.
To configure port control mode:
1. From the Port Control menu, select Port Control Mode (Main menu >
Configuration > System Configuration > Control Port > Port Control > Port
Control Mode).
The Port Control Mode menu appears (see Figure 4-23 ).
ASMi-52
Port Control Mode (Terminal)
1. Terminal
2. Dial out
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-23. Port Control Mode Menu
2. From the Port Control Mode menu, select the required operation mode.
3. From the Port Control menu, select Save to save the change.
Configuring User Name, Password, Pop-up Alarms and Security
Timeout
The user name, password, pop-up alarms and security timeout are configured via
the Terminal menu.
To access the Terminal menu:
• From the Port Control menu, select Terminal (Main menu > Configuration >
System Configuration > Control Port > Port Control > Terminal).
The Terminal menu appears (see Figure 4-24 ).
Note