RAD Data comm ASMi-52 - Manual (Page 165)

Installation and Operation Manual Appendix B IR-IP Interface Module
ASMi-52 Ver. 2.5 Erasing IR-IP Software B-29
Erasing Application Software
To erase the application software:
1. Turn ASMi-52 off.
2. Set all the four sections of IR-IP DIP switch to ON.
3. Turn ASMi-52 on and monitor the ERR and LINK indicators: they must blink
alternately.
4. While ERR and LINK are blinking (within 15 seconds), set sections 3 and 4 of
the DIP switch to OFF.
The IP router application software is erased. During the process of erasing,
the ERR indicator turns on and lights steadily.
If you do not set sections 3 and 4 to OFF within 15 seconds of power-up, IR-IP
ignores the setting of all the four sections to ON and starts normal operation. In this
case, it is recommended to turn ASMi-52 off and then back on.
Alternately, to abort the whole operation, turn ASMi-52 off, return all the four
switches to the desired positions, and then turn ASMi-52 on again.
5. Turn ASMi-52 off, and then return all the four sections of the DIP switch to the
desired positions.
Downloading New Software
After erasing the application software, you can download new software from any
computer that can serve as a TFTP client.
To enable the downloading, IR-IP automatically activates its TFTP server
application with the following factory-default IP parameters:
• IP address:
192.168.205.1
• Subnet mask: 255.255.255.252.
Connect the computer serving as a TFTP client to the IR-IP 10BASE-T connector in
the way as a Telnet host used for preliminary configuration (see the
Performing
Preliminary Configuration section). The computer IP parameters must be
configured as follows:
• IP address
192.168.205.2
• Subnet mask 255.255.255.252
• Default gateway 192.168.205.1
To download new software:
1. If necessary, turn ASMi-52 off.
2. Set all the four sections of the IR-IP DIP switch to OFF.
3. Turn ASMi-52 on.
4. Connect the computer to the IP router LAN interface (for the 10BaseT version,
verify that the LINK indicator lights steadily) and configure its IP parameters as
explained above.
Note