RAD Data comm ASMi-52 - Manual (Page 155)

Installation and Operation Manual Appendix B IR-IP Interface Module
ASMi-52 Ver. 2.5 Advanced Setup B-19
Defining the Multicast Parameters
The Multicast IP menu is used to specify the IP multicast frame forwarding
parameters, and to access the static multicast groups’ table.
To define the Multicast Parameters:
1. From the Advanced Setup menu, press 4.
The Multicast IP menu appears ( Figure B-13 ).
IR_IP <IR-IP> S/W Ver. 1.21 (date)
Quick Setup
Management Access
Advanced Setup
.....................................................................
Device identification
Interface Parameters
Protocol Parameters
Multicast IP
=====================================================================
1. Multicast forwarding :[ Disable ]
2. Static groups :>>>
Press one of the numbers to select or ESC:
Figure B-13. Multicast IP Menu
2. Specify the Multicast Forwarding. Used to control the forwarding of IP
multicast frames. The following selections are available:
DISABLED – Disables multicast forwarding in both directions.
LAN to WAN – Enables forwarding of IP multicast frames addressed to
groups appearing in the Static Multicast Groups table, from the LAN to the
WAN.
WAN to LAN – Enables forwarding of IP multicast frames addressed to
groups appearing in the Static Multicast Groups table, from the WAN to the
LAN.
BIDIRECTIONAL – Enables forwarding of IP multicast frames addressed to
groups appearing in the Static Multicast Groups table, in both directions.
WAN to LAN + IGMP – Enables forwarding of IP multicast frames
addressed to groups appearing in the Static Multicast Groups table, from
the WAN to the LAN. In addition, more groups can be added dynamically
(the additional can be viewed using the View menu –
Figure B-18 ).
TRANSPARENT – All the IP multicast frames are forwarded, irrespective of
the Static Multicast Groups table.
3. Select Static Groups to access the static multicast groups table. The table is
used to specify the IP addresses for up to 10 IP multicast groups.