RAD Data comm ASMi-52 - Manual (Page 168)

Appendix C Easy Config Device Installation and Operation Manual
C-2 Installation ASMi-52 Ver. 2.5
C.3 Installation
Package Contents
The Easy Config package contains the following items:
• Easy Config device
• AC/DC power adapter
• Interface cable with DB-9 male and female connectors.
Connecting the Interface Cable
The control port of the Easy Config terminates in a D-type 9-pin male connector.
To connect the Easy Config to ASMi-52:
1. Connect the female connector of the supplied interface cable to the Easy
Config port designated CONSOLE.
2. Connect the male connector of the interface cable to the ASMi-52 port
designated CONTROL.
Connecting the Power
Power is supplied to the Easy Config via an external AC/DC power supply or via
four AA non-rechargeable batteries.
To reduce the risk of electric shock and fire, use only AC/DC power adapters
supplied with the unit.
To connect the external power adapter:
1. Push the external power adapter plug into the round DC socket designated
5V, 1A DC.
2. Connect the external AC/DC power adapter to the mains outlet.
To insert batteries:
1. Loosen the four screws on the back cover of the Easy Config.
2. Remove the back cover by lifting it straight up.
3. Insert four AA non-rechargeable batteries into the battery compartment.
4. Replace the back cover by reversing the procedure described in steps 1–2.
Warning