Displaying the port status – RAD Data comm ASMi-52 User Manual
Page 87
Installation and Operation Manual
Chapter 4 Configuration
ASMi-52 Ver. 2.5
Additional Tasks
4-37
ASMi-52
System Status
Local
Remote
Device Type
(ASMi52_SA_M (PLASTIC)-STU_C-2W)
ASMi52_SA
Clock Source
(INT)
RCV
Software Version (2.01E24)
(2.01E24)
Hardware Version (0.00)
(0.00)
FPGA Version
(0.13)
(0.13)
Hardware Status
(NO HARDWARE FAILURE)
(NO HW
FAILURE)
PS
(WIDE RANGE PS 48-60 VDC/100-240 VAC)
(WIDE
RANGE)
MAC address
(0 20 D2 20 5F AB)
(0 20 D2 21
12)
IP address
(172.17.161.73)
(172.17.161.75)
Alarm Indication NORMAL
NORMAL
Test Indication
(OFF)
(OFF)
>
ESC-prev. menu; !-main menu; &-exit;
Figure 4-39. System Status Screen
•
Alarms are described in
Chapter 5
.
Displaying the Port Status
To display the port status information:
1. From the Physical Port Status menu, select Port Status (Main menu >
Monitoring > Physical Port Status > Port Status) to display the port status.
The Port Status menu appears (see
Figure 4-40
).
ASMi-52
Port status
Local
Remote
SHDSL
(Standard ANNEX_B, Wire mode 2W)
______
SHDSL Line
(Status: SYNC, State: DATA mode)
______
Framer Type
(SLOTTED E1)
______
EOC compatible
(PROPRIETARY)
______
Actual PSD
(ASYM_PSD_DISABLE)
______
Line rate
(2048 kbps + 8 kbps)
______
E1 interface
(IR-G704-E1/BALANCE Data rate: 2048 kbps) ______
HW status
(NO HARDWARE FAILURE)
______
Test status
(NONE)>
______
Alarm status
(NORMAL)
______
REM connected line (1)
______
(N)
ESC-prev. menu; !-main menu; &-exit;
Figure 4-40. Port Status Menu
Note