RAD Data comm ASMi-52 - Manual (Page 71)

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.5 Configuring ASMi-52 System Parameters 4-21
3 to specify the time (in sec) ASMi-52 waits for an answer after each dialing
attempt. If the called station does not answer within the specified time,
ASMi-52 disconnects. If additional call attempts are allowed,
ASMi-52 redials immediately after disconnecting. The available selections
are 30, 45, or 60 seconds.
4 to select the dialing mode. TONE, if the dial-out modem is instructed to
use DTMF dialing. PULSE, if the dial-out modem is instructed to use pulse
dialing.
5 to control the use of an alternate number. The alternate number is dialed
after the specified number of call attempts on the primary number failed.
ENABLE
, the use of an alternate number is enabled. DISABLE, ASMi-52
stops the call attempts after the specified number of call attempts on the
primary number failed.
6 to specify a primary number to dial.
7 to specify an alternate number to dial.
3. Select Save to save the changes.
ASMi-52
Dial out
1. Call Out Mode
(None)
2. Number of Retries [0-8] (1)
3. Wait for connect (sec) (30 sec)
4. Dial mode (Tone)
5. Alternate number mode (Disable)
6. Primary number ()
7. Alternate number ()
8. Save
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-26. Control Port Dial Out Menu
Setting the G.704 Interface Type
The G.704 interface type refers to the remote side hardware and is applicable for
E1 only.
To set the G.704 interface type:
1. From the System Configuration menu, select G.704 Interface Type.
2. Select one of the following values as required:
Autodetect
Balanced
Unbalanced