RAD Data comm ASMi-52 - Manual (Page 69)

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.5 Configuring ASMi-52 System Parameters 4-19
ASMi-52
Terminal
1. Change access >
2. POP ALARM (No)
3. Security timeout (10 min)
4. Save
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-24. Terminal Menu
To change the user name and password:
1. From the Terminal menu, select Change Access (Main menu > Configuration
> System Configuration > Control Port > Port Control > Terminal > Change
Access).
The following dialog appears:
ASMi-52
Change Access
1. User name
...()
2. Password ...
3. Clear User Name
...
4. Clear Password ...
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-25. Change Access Menu
2. Select User Name to enter a new user name; select Password to enter a new
password; select Clear User Name to delete the current user; or Clear
Password
to delete the current password.
3. Enter a new user name or password and press <Enter>.
The Terminal menu appears.
4. From the Terminal menu, select Save to save the changes.
To enable or disable the pop-up alarms:
When the pop-up function is enabled, ASMi-52 displays the active alarms at the
bottom of the terminal screen. When the faulty condition causing the alarm is
cleared, the alarm is removed from the screen
1. From the Terminal menu, select Pop Alarm (Main menu > Configuration >
System Configuration > Control Port > Port Control >Terminal > Pop Alarm)
to choose the pop-up alarms mode: ON (pop-up alarms are enabled) or OFF
(pop-up alarms are disabled).
The display is refreshed and the new value appears.
2. Select Save to save the changes.