Tektronix AWG610 - Manual (Page 209)

AWG610 Arbitrary Waveform Generator User Manual
3-91
Quick Editing
Quick edit allows you to modify and output the currently edited waveform (with
the waveform editor) in real time by using the knobs on the front-panel. The
Quick Edit enables you to scale or shift the cursor-to-cursor data on the
Waveform editor screen along the vertical and/or horizontal axis. Use the
vertical scale, vertical offset, horizontal scale, and horizontal offset front-panel
knobs.
If Update Mode is set to Auto with the waveform editor, waveform modifica-
tions using the knobs are automatically updated to the waveform file and to the
output waveform.
NOTE. You can enter into the quick edit mode only from the waveform editor.
Screen Display
Open a target waveform with the waveform editor, and then push the QUICK
EDIT button on the front-panel. The screen is the same as that of the waveform
editor in graphic mode except for the bottom and side buttons. A bottom button
is not available, and only three side buttons can be used for adjusting the editing
parameters. See Figure 3–20 for an example of the quick edit screen.