Tektronix AWG610 - Manual (Page 85)

AWG610 Arbitrary Waveform Generator User Manual
2-47
Tutorials
This section contains tutorials to help you learn how to operate the
AWG610 Arbitrary Waveform Generator. These tutorials provide a good
introduction to the following basic features of the instrument:
H Setting up the instrument
H Loading and outputting a sample waveform
H Creating and editing standard function waveforms
H Editing a waveform using quick editor
H Using the equation editor
H Creating and executing sequences
NOTE. These tutorials do not cover all the features and functions of the AWG610
Arbitrary Waveform Generator. They are intended only to introduce the basic
instrument functions.
By connecting an oscilloscope to the AWG610 Arbitrary Waveform Generator
and observing the waveforms output, you will understand how the AWG610
Arbitrary Waveform Generator works. The following equipment and accessories
are needed:
H A digital storage oscilloscope
(A Tektronix TDS-Series oscilloscope or equivalent)
H One 50 W SMA cable
H One 50 W SMA terminator
H One SMA (Fe)-BNC (Ma) adapter
Connect the digital storage oscilloscope to the AWG610 Arbitrary Waveform
Generator as shown in Figure 2–30.
NOTE. The CH1 LED is off when a signal is being output from CH1.
If the CH1 LED is on, turn off the output by pushing the CH1 OUT button.