Acura 2013 TL - Manual (Page 208)

You must select the ON mode by
operating the engine start/stop
button (see page
) to use the
heaters and the air ventilation
system.
To use the heaters, press the seat
heater button. The indicator (red)
above the button will come on. There
are four settings in the heaters:
HI Three indicators on.
MID Two indicators on.
LO One indicator on.
OFF All indicators off.
When you press the seat heater
button once, the heater is set to HI.
After the seat reaches a
comfortable temperature, select
MID or LOW by pressing the seat
heater button. This will keep the
seat warm. To shut down the
heater, press the seat heater
button until the indicators go off.
Both front seats are equipped with
seat heaters and an air ventilation
system. The passenger seat only has
heaters in the seat bottom because
of the side airbag system.
185
TL with Advance Package and Canadian
Elite Package models
SH-AWD with Advance Package and
Canadian SH-AWD Elite Package
models
Seat Heaters and Ventilations
204
INDICATORS
Driver’s
seat
HEATERS
Passenger’s
seat
SEAT VENTILATION
BUTTON
SEAT HEATER BUTTON
12/07/20 10:55:53 31TK4640_209
2013 TL
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls