Acura 2013 TL - Manual (Page 301)

These
modes adjust the strength of the
sound coming from each speaker.
Fader adjusts the front-to-back
strength, while balance adjusts the
side-to-side strength. To adjust fader
and balance, select FADER or
BALANCE, then press ENTER on
the interface selector. The current
setting is shown on the screen. Turn
the interface dial or VOL/
knob
to the desired level, and enter your
selection by pressing ENTER on the
interface selector. To equalize the
fader or balance, turn the interface
dial or VOL/
knob until the
marks on the sound grid come to the
center of the adjustment bar.
If the fader adjustment is set to F9
(maximum front level), the
subwoofer is turned off.
Turn the VOL/ knob or
interface knob to adjust the setting
to your liking. You can check the
level on the navigation screen or on
the center display. When the level
reaches the center, you will see ‘‘C’’
in the center display.
The system will return to the audio
playing mode in the center display
about 10 seconds after you stop
adjusting a mode.
If you do not make an adjustment
within 10 seconds, you will need to
select the mode again.
To adjust bass
and treble, select BASS or TREBLE,
and press ENTER on the interface
selector. The current setting is
shown on the display. Turn the
interface dial or VOL/
knob to
the desired level, and enter your
selection by pressing ENTER on the
interface selector.
You can also adjust the sound by
pushing the
(Sound) button
repeatedly. Each mode is shown
in
the center display as you
push the button.
Select the mode you want to adjust
by turning the interface dial then
press ENTER.
CONTINUED
FADER/BALANCE
BASS/TREBLE
Playing the AM/FM Radio (Models with navigation system)
Fe
a
tu
re
s
297
12/07/20 11:07:44 31TK4640_302
2013 TL