Blind spot information system (bsi), 2013 tl – Acura 2013 TL User Manual
Page 530
Multi-Information
Display Message
BSI Indicator
System
Status
ON
OFF
ON/OFF
OFF
Description
2
When you press and hold the BSI OFF button with the ignition switch
in the ON (II) position, a
BSI ON or OFF message is displayed on the multi-information display for about 5 seconds.
The BSI indicator will remain on while the system is off.
The BSI alert indicator illuminates or flashes according to the system status.
A chime sounds to indicate that the system has been turned ON or OFF.
1:
ON mode on models with keyless access system (see pages
and
).
If while driving, mud, snow, or ice accumulates in the vicinity of sensor:
The system may shut down
The BSI indicator illuminates, a message is displayed on the multi-information display, and a
chime sounds.
The BSI indicator will turn off and the system will return to normal once the obstacle is removed,
and you begin to drive.
Always keep the area around the radar sensors clean. BSI may not operate properly if the sensors
are obstructed.
The BSI alert indicator:
May come on when a vehicle enters one of the alert zones, even if this message is displayed.
May not come on due to obstruction (splashes, etc.) even if this message is not displayed.
2:
System status may remain on even when the BLIND SPOT NOT AVAILABLE message is displayed.
If the system is faulty, the BSI indicator illuminates and a message is displayed on the multi-
information display.
Have your vehicle inspected by your Acura dealer.
1
Blind Spot Information System (BSI)
BSI Status Displays
526
12/07/20 11:38:08 31TK4640_531
2013 TL
D
riv
ing