Acura 2013 TL - Manual (Page 307)

The encryption
code is being updated. Wait until the
encryption code is fully updated.
Channels 0 and 1 should still work
normally.
XM is loading the
audio or program information.
The channel
currently selected is no longer
broadcasting.
Once a channel is stored, press
and release the proper preset
button to tune to it.
Press the button or scroll
up again. The other XM band will
be shown. Store the next six
channels using steps 2 and 3.
Repeat steps 2 and 3 to store the
first six channels.
Pick the preset button you want
for that channel. Press and hold
the preset button until you hear a
beep. You can also pick the
number with the interface dial.
Select your desired number and
press and hold ENTER on the
interface selector.
In category mode, only channels
within that category can be
selected. In channel mode, all
channels can be selected.
Use the tune, list, or scan function
to tune to a desired channel.
The signal is
currently too weak. Move the vehicle
to an area away from tall buildings,
and with an unobstructed view of the
southern horizon.
The selected channel
number does not exist, or is not part
of your subscription, or this channel
has no artist or title information at
this time.
There is
a problem with the XM antenna.
Please consult your dealer.
The selected
channel has no artist or title
information at this time.
5.
3.
4.
2.
CONTINUED
‘‘UPDATING’’
‘‘LOADING’’
‘‘OFF AIR’’
XM Radio Display Messages
‘‘NO SIGNAL’’
‘‘ - - - - ’’
‘‘CHECK ANTENNA’’
‘‘NO INFO’’
Playing the XM Radio (Models with navigation system)
Fe
a
tu
re
s
303
12/07/20 11:08:30 31TK4640_308
2013 TL