Multi-information display – Acura 2013 TL User Manual
Page 98
You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park (automatic) or
with the parking brake set (manual).
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFT TO PARK TO CHANGE
SETTINGS’’ (automatic) or ‘‘MUST
STOP AND SET PARK
BRAKE TO CHANGE SETTINGS’’
(manual) message and you cannot
change the settings.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure the driver’s door is
unlocked with a corresponding
remote transmitter/keyless
access remote.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, move the shift lever out of
Park (automatic) or release the
parking brake (manual), the display
will change to the normal screen.
Multi-Information Display
Customized Settings
94
12/07/20 10:41:58 31TK4640_099
2013 TL
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
Models equipped with the
keyless access system have an engine
start/stop button instead of
an ignition switch. VEHICLE OFF
(LOCK) Mode is the equivalent of
LOCK (0) and ACCESSORY Mode
is the equivalent of ACCESSORY (I).
For more information, see pages
and
: